Instruction for use: Salamol Eco

Active substance Salbutamol

ATX Code R03CC02 Salbutamol

Pharmacotherapeutic group:

beta-agonists

Structure and Composition

Aerosol for inhalation dose 1 dose

active substance:

salbutamol sulphate 124 mg

(Corresponds to 100 mg of salbutamol)

Excipients: hydrofluoroalkane (HFA-134a) - 26,46 mg; Ethanol 96% - 3.42 mg

200 doses of aluminum cans with metering valve provided with inhalation device with a protective cap. In the paper cartons 1 a can.

pharmachologic effect

bronchodilatory.

It stimulates the beta 2-adrenergic receptors.

pharmacodynamics

bronchodilator.

Dosing and Administration

Inhalation.

Adults and children over 12 years: 100-200 mcg Salamol Eco (1-2 inhalation doses) for the relief of asthma attacks. To control the flow of mild asthma - 1-2 dose 1-4 times a day and an average disease severity - at the same dosage in combination with other antiasthmatic agents. To prevent asthma physical effort - for 20-30 minutes before loading dose of 1-2 at the reception.

Children from 2 to 12 years: the development of bronchial asthma attack, and to prevent attacks of asthma associated with exposure to the allergen or exercise-induced, the recommended dose is 100-200 mg (1 or 2 inhalations).

The daily dose of salbutamol should not exceed 800 mcg (8 inhalations).

Instructions for use

Check the operation of the inhaler before the first use, and if you have not used it for some time.

1. Remove the inhaler cap. Make sure that the outlet tube is no dust and dirt.

2. Hold the can in an upright position, resting on the bottom of the thumb and index finger - on top of the balloon. Shake the cartridge up and down.

3. Make the best possible deep breath (without voltage). Firmly pinch the lips outlet tube cartridge.

4. Take a slow deep breath. At the moment of inspiration, click the index finger on the valve cartridge, releasing a dose of medicine. Continue to slowly inhale.

5. Remove the tube from the mouth of the inhaler and hold your breath for 10 seconds or as much as can without strain. Exhale slowly.

6. If you need more than one dose, wait about a minute and then repeat the procedure from step 2. Put the cap back on the inhaler.

In steps 3 and 4 are not in a hurry. At the time of release dose medication is important to breathe in as slowly as possible. In the early work-out near the mirror. If you see steam coming from the top of the cartridge or of the corners of the mouth, then start again from step 2.

Shoe inhaler. The inhaler should be cleaned at least once a week. Remove the metal canister from the plastic casing (inhalation device) and rinse case and cover with warm water. Do not use hot water. Thoroughly dry, but do not use it for heating devices. Put the cartridge back in its case and put on the cap. Do not immerse the metal canister into water.

Storage conditions

In sheltered from direct sunlight, at a temperature no higher than 30 ° C. Do not freeze.

Keep out of the reach of children.

The shelf life

3 years.

Do not use beyond the expiration date printed on the package.

Available on prescription